This document describes about Model ALP111 PROFIBUS-DP communication module (for FIO) that enables to operate PROFIBUS-DP master devices and exchange data with PROFIBUS-DP devices.  This PROFIBUS-DP

communication module can be mounted on field control units (AFV30               £, AFV40£, AFV10£, and AFF50                               £), ESB

bus node unit (ANB10                 £), optical ESB bus node unit (ANB11  £), and ER bus node unit (ANR10          £).

ALP111 module has been certified by PROFIBUS Nutzerorganisation e.V. as complying with the PROFIBUS DP-V0.

ALP111-S00

ALP111-S01

Item                                                                                        Specifications

Model                                                                                            ALP111

Interface                                                  PROFIBUS-DP

Connection method                                 EIA-RS-485-compliant

Signal isolation                                        Isolated

Transmission speed                                9600 bps to 12 Mbps

Transmission route                                 Shielded

Maximum transmission distance             1.2 km per segment (at the communication speed of 9600 bps).

No. of communication port                      One port (*1)

Communication port                                 D-sub 9 pin (female) (*2)

Maintenance port                                    D-sub 9 pin (male), Interface: RS-232C

Maximum current consumption               0.7 A

Weight                                                     0.3 kg

Note: The cables and terminators must comply with PROFIBUS-DP standards (PROFIBUS Specifications IEC 61158-2/EN 50170 volume 2).

*1:  There is another port for maintenance.

*2:  PROFIBUS-DP connector must comply with the PROFIBUS-Specificaiton-Normative-parts-2.

HARDWARE SPECIFICATIONS

Hardware specifications for ALP121 PROFIBUS-DP communication module are as shown below.

Table  PROFIBUS-DP Communication Module Hardware Specifications

*1:     The cables, connectors, and terminators must comply with PROFIBUS-DP standards (PROFIBUS Specifications

IEC61158-2 type3).

 横河ALP121-S01通信模块ALP121-S01通信模块